1、关闭蒸汽安全阀，依据涨紧设备的部位调整工作压力。
1. Close the steam safety valve and adjust the working pressure according to the position of tightening equipment.
2、对机械设备，用塑胶包起來。
2. For mechanical equipment, wrap it in plastic.
3、将机器设备联接。把清洗设备接220v交流电流。
3. Connect the machine and equipment. Connect the cleaning equipment to 220V AC current.
4、对输送皮带开展淋湿。（那样做的目地是以便让输送带能更强的消化吸收清理水溶液，清理更整洁。
4. Wet the conveyor belt. (the purpose of doing so is to make the conveyor belt more able to digest and absorb the cleaning solution, and clean it more cleanly.
5、将清理水溶液与水的占比以1：10结合，拌和匀称。
5. Combine the proportion of cleaning solution and water in 1:10 and mix evenly.
6、用冲枪将清理水溶液匀称的喷洒在输送皮带上。留意输送皮带的提升边，不能用试过大的冲击力，以防损害输送带。冲枪要一次性扫完，不必反复清洗。
6. Spray the cleaning solution evenly on the conveyor belt with a gun. Pay attention to the lifting edge of the conveyor belt. Do not use excessive impact force to prevent damage to the conveyor belt. It is not necessary to wash the gun repeatedly.
7、用冷水清洗。这一情况下要细心，那样输送带的清理才会整洁。
7. Wash with cold water. In this case, be careful so that the conveyor belt can be cleaned clean.
